Hi.
I have a 2017 GLS Manual Triton that I have fitted out with full Ironman barwork..rear protection bar.. Side steps...brush bars and winch bullbar.
The advice given to me about winch fitment was that the bullbar would need to be completely removed to install a winch to the mounting plate. I thought I might save some people some guess work and advise that it is possible without removing the bullbar.
You will need to remove the plastic top trim cover (about 10 plastic screw expander clips), the grill cover (2 plastic screw clips, 2 screws into the grill cover) there is a front bar that each headlight mounts into (2 screws) the bar is removed ( 4x10mm bolts and you will need to gently lift the headlights up) the wiring harness popped off the bar. Remove the 2 horns. And you can rotate and remove this bar to give enough room to drop in the winch.
Bottom bash plates need to be removed to install the winch to plates. Cheap 12000 pound bullbar installed and brand name omitted.
Apologies as at the time I decided not to take photos and get on with the job.
Good luck.
Rae