Blue tooth not loud enough how to adjust

[daveAIR]

Blue tooth not loud enough, that is people hear me fine but i can't hear Sh#t.

I've ensured my phones volume is turned up to its loudest but no difference !!

Dave

[tritondan]

hi

i m sure some others will have an idea, but there is another thread about this somewhere that explaines you can purchase a mitsu part and install that allows adjustment of volume.

Mine is fine for volume so i have not bothered

Dan

[Crakas]

Dave,

This is my first post on this forum....

It depends on your phone..some phones are not quite compatible with the Parrot blue tooth. A good example is the Nokia 6210...it will not increase the speaker volume...

Cheers,

Barrie

[Homer]

Here's a good place to start:

viewtopic.php?f=18&t=1297&hilit=bluetooth+volume

[daveAIR]

Dogs $200 to supply and fit an amp.

Not at all impressed.

[Triton09]

Dogs $200 to supply and fit an amp.

Not at all impressed.

Got quoted $300.00 supply and fit you can imagine where did I tell them to fi it
you can buy the amp for about $120.00 to $150.00 then maybe 30 minutes to fit it I wish I earned what they charge

Gabriel

[Hillzy]

The amp is easy to fit it comes with instructions only takes about half an hour to fit.

[BVAENG]

I had a amplifier fitted by dealer because my blootooth wasn't loud enough. I found out after if turn on your ignition with both blootooth buttons held in on the dash this resets the blootooth and clears it's memory. You will hear a message come though the speakers to suggest it is resetting. You will then need to re do a connection with your phone to bluetooth. When i did mine the volume nearly blew me out of the car. This make me believe all i had to do was this in the first place!!!

[fraz91]

try this:
viewtopic.php?f=21&t=4480&start=25#p154358

i had the same problem with the bluetooth in the MMCS, but found that this helped a LOT. you can adjust the bluetooth send and receive volume in this and it doesn't affect anything else.

you can also have a fiddle with the audio settings if the stock unit isn't performing to what you want