www.newtriton.net

by **Michelle72** on Sat Apr 08, 2017 8:04 pm

Hi there, wondering if anyone else has pulled apart their exhaust manifold when fitting a new turbo and found it bowed? Trying to track down a new one in Perth, but getting nowhere fast. Can someone help?

by **jerrah** on Sat Apr 08, 2017 8:32 pm

How warped is it? Could you get it machined flat?

Wreckers should be able to source one. Alternatively I just found a few on ebay.

by **Michelle72** on Sat Apr 08, 2017 9:54 pm

It's only on one end and about .5mm. Who would be a good machinist to use?

by **Michelle72** on Sun Apr 09, 2017 12:10 pm

Anyone aware of the specs for the manifold ie. how much can be taken off the face?

by **BillMcQuade** on Sun Apr 09, 2017 5:36 pm

I'd only remove enough material to clean it up. It will probably have to be surface ground.

by **Michelle72** on Tue Apr 11, 2017 9:30 pm

Can someone give me the torque settings and sequence for the exhaust manifold?

by **NowForThe5th** on Tue Apr 11, 2017 10:02 pm

ex_torques.jpg

from:
http://faq.out-club.ru/download/l200_2006/maintenance/Service_Manual_2009_2013/2011/index_M1.htm

by **Michelle72** on Tue Apr 11, 2017 10:26 pm

Thankyou so much, I have just spent hours trying to find it.

www.newtriton.net

Exhaust manifold 4d56 mn triton

Re: Exhaust manifold 4d56 mn triton

Re: Exhaust manifold 4d56 mn triton

Re: Exhaust manifold 4d56 mn triton

Re: Exhaust manifold 4d56 mn triton

Re: Exhaust manifold 4d56 mn triton

Re: Exhaust manifold 4d56 mn triton

Re: Exhaust manifold 4d56 mn triton