Pulled centre console and centre trim out. Installed an icom 400 pro into the old radio slot. Turned out to be pretty easy, just used four screws that were there and jerry rigged a couple of brackets.
Then pulled the rear door trims off, installed some new speakers, along with a heap of dynamat over the inner door shell and around the speaker mounts.
Pulled off the front door trims and replaced the new dodgy trim clips I got from o/seas with the old originals (did the speakers and dynamat in the front doors a couple of weeks ago). Back to being tight again
Then cut the bottom off the front inner guard lining, where it hangs down below the bull bar, zip tied them into place a bit better.
Gave Matilda a quick dust off with quick detail and a cloth.
Tomorrow I'm off the BCF to get some water and fuel containers, some new chairs and a few other bits and bobs in preparation for the VIC HC trip.