4wd shifter won't move after new clutch install

Anything Triton related

4wd shifter won't move after new clutch install

Postby Kierangesler on Tue Sep 29, 2020 6:47 pm

Hi guys, I installed a new clutch in my 2008 3.2l triton. After reinstalling the box the 4wd shifter won't move. I pulled the shifter back out and can't even move the selecter with a screw driver. I have driven forwards backwards all while holding pressure on the shifter with no luck. I have jacked up the rear and front to make sure there's no load on anything and still nothing. Does anyone have any ideas why this might be happening?
Kierangesler
 
Posts: 2
Joined: Tue Sep 29, 2020 4:57 am


 

Re: 4wd shifter won't move after new clutch install

Postby Kierangesler on Wed Sep 30, 2020 7:31 pm

Just incase anybody searches this same issue... I was able to fix it by taking the cover plate off the top of the transfer case where the shifters go through and insert a 1/2 inch extension bar into the slot on the selector and pop it out of 4wd.

Kieran
Kierangesler
 
Posts: 2
Joined: Tue Sep 29, 2020 4:57 am


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 7 guests