MN ETACS P#???

[coughy]

any one happen to know the etacs p#???
i need a challenger one but wondering if the mn has one same

mine is a 18637A256//01N

the etacs is behind the fuse panel in the car
2 plugs on top and a clip to the side and she is out in under 1 min and numbers on the back

anyone help pls

as im chasing a can bus termination issue with the etacs and the engine ecu
i have just replaced the engine ecu but it is still there so next is replace the etacs ive checked the j/c joiners and they look fine


ggggggrrr hate this car

[furious]

Mate with the amount of electrical issues with your vehicle i would be taking it to an auto electrician.

I had a falcon play up and it was the dealer who replaces a brake globe use a single element rather than a twin element. simple fix that the dealer looked at 3 times and could not diagnose let alone fix.

[Stoneman]

You can get canbus issue if don’t have the option fitted its looking for

If for example if you don’t have a sunroof the ecu may still search for it.. it will come up with a time out error

[RHKTriton]

The key to can bus is that it is a bus, which also has terminating resistors at either end of the circuit.

I'm not sure if theses are external or integrated with the ecu, etacs or other possible module on the bus?

Check a manual and see if there are specific tests.

A lot of techs, me included at times, go for the obvious, complicated components first, where you should start with connectors, continuity of cabling, power supply, etc.

If its an intermittent issue, buy a white jacket with straps now!

[coughy]

no it isnt intermitant it does a termination error on the can bus all the time
i work with can bus at work so im all over the can bus system's

i have tested the wiring and the J/C connectors it has had the engine ecu replaced only thing left is the etacs all good guys im not asking for help other than the etacs out of a mn triton
i have been dealing with this animal now for 5 or so years so this POS isnt going to break me

I have the mitsubishi software and the mut3 so yes im all over it