How to remove panel behind rear seat in MN GLXR

[MN GLXR]

Guys, I removed all of the screws and little plastic connectors but I could not get the panel to budge. Anyone removed it?


Cheers MN GLXR

[dan.batto]

I'm going to guess its like most things on the triton...pull! But don't quote me as I've never removed it!

[motoz]

Yes it's a right royal PITA !!! There's about 7 speed clips that hold it in place. I found it easier to start in the centre at the top and pop the first one then work around to the bottom corners.

You may want to get some spare clips and a packet of Bandaids as your very likely to break a few and skin your knuckles in the process.

[odie602r]

You're talking about the ones to the sides behind the rear seat?

If so, you need to kind of pull up (as in towards the roof) and in (as in towards the centre of the cab) at the same time, or close to it.

There's some inner clips at the top part that need the centre pull first, then the bottom clips require the panel to be pulled up. Towards Centre first, Then up.

I found getting it back on way harder than pulling it off though - something for you to look forward to....!

[Cowboy Dave]

Also there are small raised circles on the plastic to show you where the clips are.

[Longranger1]

You will probably have to buy some more genuine panel clips after removing the panel - there are 2 different sizes used on that panel.

[MN GLXR]

Thanks guys. I'll grab the sledge hammer and sort it out.