Homer wrote:If you get no takers, if someone sends me a gasket for a sample, I'll get 20 or so laser cut for you oilers....but you'll owe me one
Homer wrote:Homer wrote:If you get no takers, if someone sends me a gasket for a sample, I'll get 20 or so laser cut for you oilers....but you'll owe me one
By this I just mean the original gasket from Mits....I'll somehow figure out how to make it from steel and not put a hole in it
Any takers on sending the Mits gasket?
Eelesy wrote:or just to state the obvious... are you turning it the right way???
snowman wrote:ok how about this proposal.
Looks like there will be 10+ takers for this EGR blanking plate at least.
ok so Homer has offered to get something laser cut for us (i assume he knows someone who drinks and has a laser cutting thingy) which with these quantities is a far better way than someone manually cutting them out.
Postage will be trivial i would expect for a single plate.....so if we all throw in $10-$15 bucks that should cover the material and a case of beer wouldn't it?
can we agree on 0.5mm stainless?
homer you up for it?
....just need to find a gasket to trace......
Blue wrote:snowman wrote:ok how about this proposal.
Looks like there will be 10+ takers for this EGR blanking plate at least.
ok so Homer has offered to get something laser cut for us (i assume he knows someone who drinks and has a laser cutting thingy) which with these quantities is a far better way than someone manually cutting them out.
Postage will be trivial i would expect for a single plate.....so if we all throw in $10-$15 bucks that should cover the material and a case of beer wouldn't it?
can we agree on 0.5mm stainless?
homer you up for it?
....just need to find a gasket to trace......
x2
Sounds like a plan Snowman... Count me in...
Users browsing this forum: No registered users and 18 guests