broken top plastic part off fuel injector

[brett_weld]

Hi everyone, dropped triton in at local mechanic today and after picking inlet manifolds up and spending a couple hours cleaning them went back to find that a injector has snapped during them trying to get plug off to do the valves. My question is if there is a way to replace top plastic where plug connects or is a new injector required. If so does anyone know someone with a injector or where I can get a injector from.Mechanic is going to get on to it tomorrow but thought id try here first. Thanks in advance. Brett

[TUFF TROOP]

Will need a new injector mate! I have one if you need one message me

[brett_weld]

Thanks tuff troop pm sent

[Tony]

Yep as above, replacing the injector be the easiest way for you. Few of us have spares these days. Grab one off Troop as I prefer to keep mine as a set. Don't toss the old item out as may be recycled.

[brett_weld]

Thanks for the reply Tony. Hopefully can get one off tuff troop. On another note cant wait till your resistor mod arrives really keen to get it on with the manifolds clean and service done. Hanging to see the difference .

[Robo1]

Hey Tony does your resistor mod suit MN Triton as well Regards Robo

[har05l]

Hey Tony does your resistor mod suit MN Triton as well Regards Robo

Yes it does robo