List of commonly used parts and part numbers.

[mattz]

ML 3.2l
Radiator hoses from Repco (I think they are Mackay brand)
top CH5571 trade price $63
bottom CH5572 trade price $115
Cabin filter ECA206C

I think you'll find the genuine items are a bit cheaper.......I know the top hose is about half that. .

[Snooozy]

yeah, I thought they sounded rather expensive.
that's why I didn't get them. only looking at having some spares for the trip.

[RHKTriton]

Help

Anyone got the correct replacement options for the AC drive belt on the 08 3.2 motor.

I can't find any Mitsi to Dayco or Gates cross references.

Most site show a 13A0900 and this is way too short! It won't even fit over the pulleys with tensioner.

Thanks in advance.

[biggibbo]

13A0900 is the right part number

[RHKTriton]

Yes biggi, the part number is the only one I can find, however the dang belt is miles too small, can't even get it over the pulleys with the tensioner removed.

Unfortunately, everyone only had one specimen in stock, so if its labelled wrong, I had nothing to compare with.

Amazing how much quieter it is with just the new alternator belts. Putting on the old AC belt back on returned some squealing.

[Tryton08]

I replaced mine a couple of weeks ago I thought the same. Eventually got it on after spilling some blood and swearing lots the other two are easy. If its any help I did it from under the motor and turned the crank shaft to roll it on once I got it It had to be tensioned a little. I doubt you would be able to put the tensioner on later.

[mattz]

Have you released the tension from the tensioner pulley?
You shouldn't have to remove the pulley.

[RHKTriton]

Saga complete now mattz.

I removed the tensioner pulley completely at one stage and couldn't get the specified belt anywhere near getting on.

In the end the only belt I could find was the same as the original that came off = 13A0925

The alternator were as specified = 11A0950 x 2

I'd say a 13A0915 may be ideal for the AC as the tensioner is within a cm from fully tensioned with either the orig or new belts.

Agree the AC belt is much easier from below. I took off the small fan shroud section - gives good access.

Nice a quiet now.

[Snooozy]

Top Radiator Hose MN135041 $17 Use KY jelly to fit
Bottom Rad Hose MN135049 $36 As Above
Thermostat 1305A277 $29 (Includes Gasket)
Aircon Compressor Belt MB813344 $35 OR use 13A925 belt
Fan / Alt Belt Set (2 belts) 1340A032 $25 OR use 2x sequentially numbered 11A955 belts
Oil Filter 1230A046 $44
Air Filter 1500A098 $64 - Check often - if dirty these filters bypass; i.e. dirt gets through the filter panel (not around it)
LH Rear Mudflap MN117455 $73
LH Front Inner Guard Liner (called SPLASHSHIELD) 5370A277 $35 (Includes Clips/ Fasteners)
RH Front Inner Guard Liner (called SPLASHSHIELD) 5370A278 $35 (Includes Clips/ Fasteners)
Fuse 10 Amp MS810892 $2
Fuse 15 Amp MS810893 $2
Fuse 20 Amp MS810894 $2
Front Brake Pads Bendix DB1774-4WD $90

are these belts correct. different size to what was recently mentioned

[GLRkenny]

For as long as I can remember the a/c belt always seemed to be one of two options, either 13a900 or 13a925, sometimes the 900 fits and sometimes it doesn't

[RHKTriton]

Getting that 900 belt over the AC pulleys is like stretching a mozzie's arose over a bucket - very unlikely! (On ml)

[Snooozy]

this site might be of use to a few folks

http://www.tridon.com.au/PartFinder/Mit ... Any%20year

[coughy]

just found this snooozy

http://www.ebay.com.au/itm/BOSCH-DRIVE- ... 463f52bf3c

might help you

and for a triton it is

http://www.ebay.com.au/itm/DAYCO-MITSUB ... 20f679aa83

[Snooozy]

that 2nd one is no good for the ML.
ML's don't have the 2.5l in Aus.

The ML 3.2 has 2 std type V belts for fan & another for AC

I purchased my spares before the last trip through Mitsi. Got trade price so did ok

[BattleBorn91]

MN 2.5 Oil Filter
RYCO - Z313. $60.

[Snooozy]

not sure if it has been posted in this thread

Glow Plugs

Mitsubishi part number ME203539
Bosch part number GPM904
NGK part number CZ251

[coughy]

are they for a 3.2 snoozy??

[Snooozy]

are they for a 3.2 snoozy??

from what I can tell they MAY fit the 2.5 also. just check before ordering

[coughy]

yer i had a captain cook but it is a bit hit and miss
as this 2.5 is a shit to get parts for

[Noriek1956]

Hi all
i agree with the part number for aircon belt to me seems to small, an efort to put on, had the luxery of fitting in driveway at home and not out somwhere