Single piece hard cover install

[singlemalt72]

Just wondering if anyone has access to the instructions for installing a single piece (mitsubishi) hard lid for a MN.

I have searched and found the instructions for a 3 piece, but have an offer of an insanely cheap one-piece that is hard to pass up.

[RHKTriton]

About to go hunt down my instructions for the lid (ML) and then realised your looking at the MN.

One way you could do it without is to place the lid in its rest position with the tail gate down.

Crawl in and connect the hinge bits that rivet onto the tray and mark out the holes for the rivets.

You should also be able to locate where the lock bits need to be mounted.

Someone with a MN lid should also be able to give you the distances from a reference point to the strut mountings.

[singlemalt72]

That's what I was thinking of doing, though if anyone has a 1 piece lid on an mn and wants to measure up the mounting holes I'd be much obliged.

[Morgs n Jess]

ill have a measure up tomorow if i remember champ. pretty sure all my old holes are still visible.

[goosey1812]

Did you ever get this sorted? Looking at doing the same to my new MN.