Be careful when buying any ebay snorkel kit that comes with a cylindrical stainless steel radiator coolant overflow bottle, to replace the white plastic factory bottle. All (I believe) snorkel kits will require you to relocate, trim or replace your coolant overflow bottle as it gets in the way of the snorkel joiner into the filter box.
http://www.ebay.com.au/itm/New-Snorkel- ... 43bde04550
The stainless steel replacement is intended to mount across the front of the engine bay, using the same holes used by the power steering reservoir. Plus, the bracket at the bottom of the cylinder has 2 holes that do not match up with anything in the bottom of the engine bay.
I contacted the ebay shop to point this out, and they basically shrugged, said "too bad, we're just a reseller, not an engineering company, I guess you'll have to relocate the power steering reservoir or find another place for the overflow" !!
You'll know there's not a lot of space in the engine bay. I've got my Provent 200 mounted off the back of the filter box, and theres not much more space available near the front.
I nearly bought a similar kit from ebay store juleslife4x4, which apparently provides a slightly smaller white plastic overflow bottle, which looks factory standard. This would have been a safer bet.
http://www.ebay.com.au/itm/Mitsubishi-T ... 3386e847f2
The ebay store said their stainless steel replacement is a copy of the Safari Snorkel kit, and the white plastic one from other kits is copied from the Ironman 4x4 kit. Can't say if this is true either way, but interesting....
This is the bottle I received, which shows my dilemma.
I'm probably going to leave the factory overflow bottle in place, and try to figure out a better way of mounting it. I remember reading about people removing the plastic mounting lug, plastic welding and other solutions.... bit more research to do I guess.
