Hi, I just bought a PS4X4 Jack rear bar and are having troubles with how its mounted and wanted to see if anyone else has one and what theirs is like.
The Bolt hole on the underside of the chassis which the OEM tie down point was bolted to doesn't line up with the slot in the bar but the bigger hole in the chassis which is about a 1" hole does this seems a bit off to me would you agree this isn't how it should be mounted? For the time being I made a doubler plate to spread clamping force over each side of the hole until I work out what to do with it.
Also the bar sits closer in to the tub on the back at the left but the side hoop on the left has a bigger gap then the right (about 20mm vs 5mm) anyone else who has one does theirs sit crooked like this?
Just trying to work out if its worth the hassle to send it back if its only going to get replaced with one just as bad or just suck it up as a lesson to not be cheap haha.
Cheers