GLX-RSilver wrote:Hey greedy the standard gearbox bolts haven't got enough thread to fit a 10mm spacer between the crossmember and the gearbox mount. So i'm planning of making spacers for the crossmember to chassis to lower it, Then i'm going to weld a plate where the gearbox mount mounts with recess holes to bolt the gearbox mount lifting the gearbox back up to my required angle.
I hope you understand what i'm planning to do, when i have done it i'll post photos
Cheers
Hey Wallace as far as i know the auto tailshaft has no slip joint.
Cheers
Buzzy wrote:GLX-RSilver wrote:Hey greedy the standard gearbox bolts haven't got enough thread to fit a 10mm spacer between the crossmember and the gearbox mount. So i'm planning of making spacers for the crossmember to chassis to lower it, Then i'm going to weld a plate where the gearbox mount mounts with recess holes to bolt the gearbox mount lifting the gearbox back up to my required angle.
I hope you understand what i'm planning to do, when i have done it i'll post photos
Cheers
Hey Wallace as far as i know the auto tailshaft has no slip joint.
Cheers
GLX-R,
You got around to doing this yet?
Return to Drive Train Components
Users browsing this forum: No registered users and 9 guests