Tex wrote:If you know a mechanic well they would probably install the blank if you supply it but they wont even write it down or admit to it.
mad992 wrote:cant complain about that for service joshcw
jonb1760 wrote:Recently put in Tony's mod( thanx Tony). Didn't really notice any difference in performance. I know that this is not a performance enhancing g mod so no big deal. One thing I notice is that when I start it of and drive down to the gate, about 150 meters and the display is showing approx 40l/100klms. Approx. Again it's no big deal as by the time I get to work, about 6klms,it's down to about 9 ish. I never noticed this before the mod and just wanted to see if anyone else has seen this as well.
lazarus wrote:Great post Tex, just a bit of correction
as shown on the picture for 2.5 l MN (which I actually shot ), you said blank should go to the center of the picture just below EGR valve, BUT heaps of other users, mechanics and experienced guys on this forum said and recommended that blanking plate should go to the left of the location you described, just under that steel heat shield
I have it there for the past 11 000 km and not a single limp since install, no 6mm hole
Users browsing this forum: No registered users and 0 guests