Hi guys,
In the GLS all you have to do is put your fingers in underneath the black facia near the seatbelt warning and pull out gently. The facia is only held on by clips. Pretty sure the GLX would be the same.
Stick your head in the drivers footwell and look up and towards the centre whilst turning the HVAC knobs. You should be able to see the cables and where they connect to the HVAC box. There is two cables on one side and one on the other. (behind the glovebox)doosra wrote: Tried locating the cables but can't seem to find it.
Rotary dials or climate control though? I think the climate control models are much easier to pull apart!Logzy wrote:It was a lot easier than I thought it would be.
flomax wrote:Attempting this project tomorrow.. installing a Sony XAV AX-100 media unit w/ aerpro facia into a stock MQ GLX+. Should be easy enough hopefully.
Found a few vids that demonstrate Mitsubishi curent way of removing the front console panel on their other vehicles, that I assume are similar to Triton useful here :
https://www.youtube.com/watch?v=4eBuulmRXC8
https://www.youtube.com/watch?v=DPuovrgsA_M
https://www.youtube.com/watch?v=joOUc9QUSDw
https://www.youtube.com/watch?v=3pqeA6h2jnY
https://www.youtube.com/watch?v=iEKPG_UoC0Y
EDIT : Service Manual MQ 2016 2017 - http://mmc-manuals.ru/manuals/l200_v/on ... dex_M1.htm
Will document my process as thoroughly as possible & report back soon
bobski wrote:Hi, just added a new aerial and thought I'd post what I did for the GLX ('15 model).
Users browsing this forum: No registered users and 1 guest