dieselweasel wrote:Where abouts on the tray do you want it to sit?
dieselweasel wrote:Would you put four little holes in the tub liner?
dieselweasel wrote:Steel bar. Steel bolts and a couple of dots of weld?
dieselweasel wrote:Sounds good, maybe use a tap and die set to put a thread into the bar holes, this should be an extra assurance that the bolt won't turn (as long as the holding bolt remains tight)
snakesoup wrote:Why dont you want to drill holes in the tub?
Sent from my SM-G900I using Tapatalk
dieselweasel wrote:Tricky one.... Im not sure what you mean about the padlock thing, i can't visualise what you're saying. I'm not totally sure of other options without a few cheeky holes in metal
TheSheepKed wrote:Thanks for the idea. I'd prefer not to drill into the tub though. Looking for a non-permanent solution but also relatively secure. Not going to have too expensive things in there, just ropes, some hand tools, clothes etc.
dieselweasel wrote:I getcha now, i didnt realise the mn had middle tie down points, my ML just has one in each corner but i spose with the oversized tray, more is good. Are you going to be using the u clamps pictured below?
You could use that for the middle tie down point on the left top of the chest and if you fit another on the right hand side, you could just bungee cord thst one to the rear tie down point so it won't move about as you zoom about.
Users browsing this forum: No registered users and 42 guests