I put those on mine early last month as mentioned in the thread above. I have mine recessed into the bumper itself though. I bolted mine to the body behind the plastic bumper.
didnt fancy cutting the whole circle out grant before i saw how they looked,then when i bolted them to the plastic i found they were solid there so i decided leave em be
Photo reminds me of how low the towbar normally sits - mines now got the rear bumper removed, & towbar modded to sit level with lower edge of number plate.........
Tip # 1 - Avoid stress & grief & low resale values with vehicles - do it once - do it right, buy a HILUX!!
I got mine from TRIGLXR and they are great! Have a look at my profile for pics! They are pretty easy to wire up, and took around 45mins all up...imcluding cutting holes and running wires!
Be carfeul when wiring up reversing lights as there are laws that need to be followed.
This has been discussed on 4wd monthly forum.
they have to be wired in to the reversing circuit and if you want a manual switch it can not be in the cabin/reached of the driver.
Not sure if this all states as alot of the blokes on 4wd monthly were from Qld and they are having a big crack down on vehicle modifications.
Most were wiring with a double switching relay.
One side of the relay was wired to the reversing circuit so when in reverse they come on automatically and then run a seperate power supply with a switch in the back of car to the second side of the relay.
i wired mine up exactly as king triton said, except i put a switch in the dash.
they come on via a relay when reverse is engaged, and i ran a completly different circuit so just the extra reverse spotties would come on when i hit the switch.