"Someone go and adjust their wastegate linkage....."
Already done but I only screwed mine back two complete turns, I also have DP Chip.....
"Someone go and adjust their wastegate linkage....."
variflex wrote:Where do these blanking plates come from that i have been reading about, are they something you guys are having made by your local engineering company or are they a mitsubishi part?
Do I need to blank off the EGR before I adjust the wastegate actuator?
variflex wrote:Where do these blanking plates come from that i have been reading about, are they something you guys are having made by your local engineering company or are they a mitsubishi part?
Do I need to blank off the EGR before I adjust the wastegate actuator?
daryn wrote:Well I could not wait the week or two Snowman.
Tackled this MOD tonight as I was bored, Alex, awesome instructions, worked a treat.
So I have Buttgauge installed and was able to get 16.9 boost on the reading, it flashed 17.0 at one point but that may have just been the blurr of night as I was testing it on the first run.
Many thanks Alex for your tips and posts once again, whats next on the list ?
GLX-R Alex wrote:variflex wrote:Where do these blanking plates come from that i have been reading about, are they something you guys are having made by your local engineering company or are they a mitsubishi part?
Do I need to blank off the EGR before I adjust the wastegate actuator?
No you can adjust it up for 2psi more boost any time...
The EGR plate is to stop farking black soot contaminating the inlet manifold..
snowman wrote:
i cant help but feel that the adjustment would provide better results for those with 'chips' as they already have a fuel increase to go with this air increase.
Eelesy wrote:i did mine yesterday, happy to say i didnt drop the pin once! haha
Users browsing this forum: No registered users and 1 guest