dan.batto wrote:Damn that engine bay is clean!! Looks good mate!!!
What kind of wire do you run? I'm looking at getting a roll seeing as I use so much, and with some of my future plans as well I could use it!
Joe wrote:Just finished reading the whole thread motoz. Great write up and pics. You've done an awesome job.
jab461 wrote:Top looking rig there Motoz! You've done a great job!.. Mate just a couple of questions
* I noticed you run a Unifilter, any dramas with oiling up the "Maf" sensor? & did you notice any diference in swapping it over?
jab461 wrote:
* You've put the "Blanking Plate" in, has it thrown up any fault codes? Did you notice any diference when you installed it? I'm gathering you havn't installed a chip?
jab461 wrote:I've also got a MN auto, engine wise it's stock ( apart from cutting the cat and muffler out ) I'm going up to Cape York next month and I'm. It sure if I should start doing some engine mods now or just leave it standard for the trip?..... Any tips?
4WD Supplies wrote:Look's good and just the right height. Looks like youve got dibs on collecting the firewood for the next few trips.
Mattstruck wrote:Any news on the chip front Dave?
Mattstruck wrote:Good times mate
Like those Good Years. They are aggresive for an AT Whats road noise like compared with your old MTs?
motoz wrote:Mattstruck wrote:Good times mate
Like those Good Years. They are aggresive for an AT Whats road noise like compared with your old MTs?
There actually very quiet. I was pretty surprised. My old ATZ's had a roar about them where these have a slight hum.
Users browsing this forum: No registered users and 5 guests