wi53yz_4wd wrote:where can I get a blanking plate from.
burnah wrote:lufc wrote:hi all
exuse my stupidness, but it is unclear to me were to block of the egr, the photos in this thread seam to be off the 3.2, i have a 2.5 and am unsure which one to blank off
please help
lufc wrote:thanks heaps burnah, that is the one i was looking at ,the other end seams hard to get to
have you had any issues since blanking the egr
Tex wrote:It has been suggested that the blank should go on the left side under the heat shield (looking at Burnah's pic). Perhaps someone in the know will clarify
burnah wrote:lufc wrote:thanks heaps burnah, that is the one i was looking at ,the other end seams hard to get to
have you had any issues since blanking the egr
None at all mate.
Just more power and less lag.
I've done the MAP mod as you've probably noticed by my photo spam over the last few pages.
burnah wrote:Tex wrote:It has been suggested that the blank should go on the left side under the heat shield (looking at Burnah's pic). Perhaps someone in the know will clarify
There were so many opinions about this that I just chose the spot that was easiest to get to. I'd be happy to move it if there's a valid reason. Anyone?
lufc wrote:burnah wrote:lufc wrote:thanks heaps burnah, that is the one i was looking at ,the other end seams hard to get to
have you had any issues since blanking the egr
None at all mate.
Just more power and less lag.
I've done the MAP mod as you've probably noticed by my photo spam over the last few pages.
just made and fitted a blanking plate took me 30 mins
is the map mod needed as part of the egr blanking plate
odie602r wrote:I recall there being talk about the blanking plate being after the EGR cooler, and that somehow this could potentially prevent damage should the EGR cooler break down/let go?
burnah wrote:odie602r wrote:I recall there being talk about the blanking plate being after the EGR cooler, and that somehow this could potentially prevent damage should the EGR cooler break down/let go?
This was my main source of confusion. I couldn't figure out which side was "before" and "after". I also couldn't work out why the cooler would "break down/let go".
wi53yz_4wd wrote:when fitting a blanking plate is gasket goo or any thing like that required
odie602r wrote:This is what swayed me ...
burnah wrote:odie602r wrote:This is what swayed me ...
So you've put it where I have?
lufc wrote:just drove home from work after fitting the blanking plate , good bye lag
exellent improvement for such a simple mod
Users browsing this forum: No registered users and 4 guests